Liquid Level Detection – Well Probe.

10 May

Liquid Level Detection – Well Probe.

By ALVI  

ALVI India in association with ALVI Australia takes pride to offer Fischer – NB10 Well probe for liquid level detection.

Application

Measuring probes for hydrostatic measurement of fluid fill-levels. Some examples of typical applications are water or fluid fill-level measurements in
• Wells
• Drill holes
• Wastewater systems and
• Containers
Most Important Features
• High measuring accuracy
• Low hystersis
• Corrosion-resistant materials
• Integrated measurement converter
• Measured values stable over time

Design and Principle of Operation
This measuring probe is designed around a highly sensitive pressure sensor with a silicon membrane-measuring element.
A DMS resistance bridge is attached to the rear of this membrane using a thin-film method. The well probe is equipped with an indirect hydraulic pressure sensor in order to guarantee the system-inherent dead space latitude. The pressure sensor is isolated by an elastic membrane from the medium to be measured. The volume between the membrane and the pressure sensor is filled completely with a transfer fluid. When pressure is applied this silicon membrane deforms in the elastic region, altering the resistance of the resistance bridge in a response linear to the measuring pressure. These changes in resistance are converted by electronics built into the device into standardized electrical signals.

Electrical Connection
State connecting cable (length) in order text
Operating Voltage
24 V DC
Installation Instructions
The connecting cable can be used up to a depth of 100 m without requiring pull relief.
Smallest cable bend radius: 120 mm; Accessory: Cable holder Model: MZ81


Electrical Connection
The well probe is connected electrically using the attached permanent cable. This cable has an internal tube to compensate for variations in air pressure that could influence the measuring result. The cable must be inserted into the connection compartment with no interruptions or extensions. A casing with protection class IP 65 that allows for pressure compensation through the internal tube should be used to cover the connection.
Special models with overload protection (lightning arrester) or explosion hazard models are available on request.

For more details please contact us , 01412293968