μGard®2 (developed by MSR) is the new exchangeable sensor unit that is capable of digital value processing, temperature compensation, and self-control for the continuous monitoring of the ambient air to detect SO2 Toxic gas.
The MC2-X-E1196-X-X is a sensor element at its core with many possible customizations. The beauty of the microgard 2 system is a microcontroller integrated into the Electrochemical SO2 sensor module. The integrated temperature compensation ensures the highest accuracy, selectivity and reliability despite the long calibration interval. The microcontroller calculates a linear 4-20 mA (or 2-10V) signal out of the measurement signal of the Semi-Conductor sensor and also stores all relevant measured values and data of the sensor element.
Calibration is a breeze with this modular design allowing easy swapping of the sensor unit or via the use of the integrated calibration routine directly at the system.
FEATURES
Digital measurement value processing incl. temperature compensation
Data / Measured values stored in the microcontroller on the sensor unit allowing easy swap of an old sensor with a newly calibrated sensor.
High accuracy, selectivity, and reliability
Low zero point drift
Sensor life time: Refer the datasheet
SIL2 Compliant development process
Easy maintenance and calibration by the exchange of the sensor module or by integrated on-site calibration.
4-20 mA (or 2-10V) analog output with selectable signal output for special mode, fault etc.
Reverse polarity protected, overload and short-circuit proof
Integrated heating down to -35°C
Optional:
Without housing
With housing Plastic: Type D, 94 x 65 x 57 mm
4-20 mA output signal
2-10 V output signal
With display for values and operation, 2x open collector for horn and warning lamp
Conformity to: o EN 378 o EN 45544 o EN 50104 (for O2) o EN 50271 o EN 50545 o EN 61010-1 o ANSI/UL 61010 1 o CAN/CSA-C22.2 No. 61010-1 • Duct mounting kit (accessory)
Built for standard output of 4-20 mA / 2-10V analog signal output, this transmitter is compatible with the PolyGard 2 series controllers & Sensor Boards as well as any other electronic control or automation system.
Sulphur Dioxide Gas Detector and Monitor ALVI Automation (India) Pvt Ltd, a Division of ALVI Technology Pty Ltd, Australia ( Td/As Gas Alarm Systems) is pleased to introduce our world-class cutting edge Sulphur Dioxide (SO2) Gas Detector and Monitor. We are involved with designing, engineering, implementing, calibrating in the field of Gas Detection Systems, Instrumentation, … Continue reading “Sulphur Dioxide Gas Detector and Monitor”
ALVI Automation – India (http://www.alviautomation.com) in association with Gas Alarm Systems – Australia (http://www.gasalarm.co.au) offer Sulphur Dioxide SO2 Transmitter ADT-53-1196, For the detection of sulphur dioxide within a wide range of industrial and commercial applications. APPLICATION:- For the detection of sulphur dioxide within a wide range of industrial and commercial applications. Due to the standard … Continue reading “Sulphur Dioxide SO2 Sensor Transmitter ADT-53-1196”
ALVI – India (http://www.alviautomation.com) in association with Gas Alarm Systems – Australia (http://www.gasalarm.co.au) take pride to offer Sulphur Dioxide Analog Sensor Transmitter. DESCRIPTION SO2 transmitter including digital measurement value processing and temperature compensation for the continuous monitoring of the ozone concentration in the ambient air. A comfortable calibration routine with selective access release is integrated … Continue reading “Sulphur Dioxide Analog Sensor Transmitter”
µGard®2 Sulphur Dioxide Gas Transmitter MC2-X-E1196-X-X GasAlarm
µGard®2 (developed by MSR) is the new exchangeable sensor unit which is capable of digital value processing, temperature compensation and self control for the continuous monitoring of the ambient air to detect SO2.
The MC2-X-E1196-X-X is a sensor element at its core with many possible customization's. The beauty of the microgard 2 system is a micro controller integrated into the Electrochemical SO2 sensor module. The Electrochemical measurement principle with the integrated temperature compensation ensures highest accuracy, selectivity and reliability despite the long calibration interval. The micro controller calculates a linear 4-20 mA (or 2-10V) signal out of the measurement signal of the Electrochemical sensor and also stores all relevant measured values and data of the sensor element.
Calibration is a breeze with this modular design allowing easy swapping of the sensor unit or via the use of the integrated calibration routine directly at the system.
FEATURES
Digital measurement value processing incl. temperature compensation
Data / Measured values stored in the micro controller on the sensor unit allowing easy swap of a old sensor with a newly calibrated sensor.
High accuracy, selectivity and reliability
Low zero point drift
Sensor life time > 15 years
Easy maintenance and calibration by exchange of the sensor module or by integrated on-site calibration.
4-20 mA (or 2-10V) analog output with selectable signal output for special mode, fault etc.
Reverse polarity protected, overload and short-circuit proof
Integrated heating down to -35°C
Optional:
Without housing
With housing Plastic: Type A, 90 x 130 x 57 mm IP65
4-20 mA output signal
2-10 V output signal
Built for a standard output of 4-20 mA / 2-10V analog signal output, this transmitter is compatible with the PolyGard 2 series controllers & Sensor Boards as well as any other electronic control or automation system.
IECEx Sulphur Dioxide Gas Transmitter PX2-X-X-E1196-B PolyXeta II.
Microprocessor based analog gas transmitter with 4–20 mA output signal for monitoring the ambient air and detecting toxic concentrations (0 – 20 ppm) by means of a catalytic sensor (Electro-chemical). The MSR gas transmitter is used to detect combustible and toxic compounds in areas classified as Group I.
Features
(0) 4-20 mA analog signal output
Comes in sealed unit which is safe for opening in Zone 1 without switching off.
IECEx Certification MSR Electronic
The sealed version option allows opening of case while in operation in hazardous area.
SIL 2 Certification for RS485 / 4-20 Analog / Relay for safety functions
ATEX Certifications MSR Electronic
Continuous Monitoring
Microprocessor with 12 bit converter resolution
Self diagnostic procedure
Easy Calibration, housing can be opened in zone 1, during operation.
Reverse Polarity / Overload Proof
Certified for Zone 1 / Zone 2
Optional Extras:
LCD display
Relay Set & LCD
Relay Set
Built for a standard output of 4-20 mA analog signal output, this transmitter is compatible with the PolyGard series controllers the MGC/DGC as well as any other electronic control or automation system.
µGard®2 Sulphur Dioxide Gas Transmitter MC2-X-E1196-X-X GasAlarm
µGard®2 (developed by MSR) is the new exchangeable sensor unit which is capable of digital value processing, temperature compensation and self control for the continuous monitoring of the ambient air to detect SO2.
The MC2-X-E1196-X-X is a sensor element at its core with many possible customization's. The beauty of the microgard 2 system is a micro controller integrated into the Electrochemical SO2 sensor module. The Electrochemical measurement principle with the integrated temperature compensation ensures highest accuracy, selectivity and reliability despite the long calibration interval. The micro controller calculates a linear 4-20 mA (or 2-10V) signal out of the measurement signal of the Electrochemical sensor and also stores all relevant measured values and data of the sensor element.
Calibration is a breeze with this modular design allowing easy swapping of the sensor unit or via the use of the integrated calibration routine directly at the system.
FEATURES
Digital measurement value processing incl. temperature compensation
Data / Measured values stored in the micro controller on the sensor unit allowing easy swap of a old sensor with a newly calibrated sensor.
High accuracy, selectivity and reliability
Low zero point drift
Sensor life time > 15 years
Easy maintenance and calibration by exchange of the sensor module or by integrated on-site calibration.
4-20 mA (or 2-10V) analog output with selectable signal output for special mode, fault etc.
Reverse polarity protected, overload and short-circuit proof
Integrated heating down to -35°C
Optional:
Without housing
With housing Plastic: Type A, 90 x 130 x 57 mm IP65
4-20 mA output signal
2-10 V output signal
Built for a standard output of 4-20 mA / 2-10V analog signal output, this transmitter is compatible with the PolyGard 2 series controllers & Sensor Boards as well as any other electronic control or automation system.
MSR – MA-5-1196 Sulphur Dioxide Gas Sensor
Sulphur Dioxide (SO2) – sensor for the continuous monitoring of gases and vapors in the air, 4 – 20mA analog signal output and can be used for car park applications.
Jewelry manufacturers are increasingly worried about their worker’s health and safety conditions, Most jewelry companies want to prevent work-related illness and injury, and they also want to prevent pollution from their manufacturing processes, we have Smart Gas Detectors for Jewelry Manufacturing & Polishing Industries. Most of the gases/solvent acid used or generate during the Jewelry … Continue reading “Hydrogen Cyanide gas detection in Jewelry Industries”
Jewellery manufacturers are increasingly worried about their worker’s health and safety conditions, Most jewellery companies want to prevent work-related illness and injury, and they also want to prevent pollution from their manufacturing processes, we have Smart Gas Detectors for Jewellery Manufacturing & Polishing Industries. Most of the gases/solvent acid used or generate during the Jewellery … Continue reading “Gas Detectors for Jewellery Manufacturing & Polishing Industries.”
Toxic Gas detectors / Sensor Transmitters By MSR Germany Gas detector or sensor transmitter for online, continuous monitoring of all toxic gases as below. These transmitters offer industry standard analog output in current or voltage form, or digital signals like Modbus RTU with RS485 serial interface. Optionally, these are also equipped with potential free relays. … Continue reading “Toxic Gases – Sensor Transmitter / Detectors / Analyzer / Monitroing – Non Ex proof”
