MSR Germany PX2-2-xxxx-A LPG Liquefied Gas Sensor For Industrial and Biogas Plants

22 September

MSR Germany PX2-2-xxxx-A LPG Liquefied Gas Sensor For Industrial and Biogas Plants

By ALVI  

ALVI  Automation – India (http://www.alviautomation.com)  in association with Gas Alarm Systems – Australia (http://www.gasalarm.co.au) offer MSR Germany  PolyXeta 2 – sensor series for combustible and toxic gases in Zone 1 and Zone 2 with SIL2, ATEX and IEC EX  all 3 approved Certified world’s First Sensor.

Sensor for combustible gases in zone 2
Microprocessor based gas sensor with 4 – 20 mA / RS485-Modbus output signal, alarm and fault relays (all SIL2 certified) for monitoring the ambient air to detect combustible gases and vapors within the lower explosive limit (LEL) by means of a catalytic sensor element (pellistor) or an infrared sensor element. The calibration of sensors without LCD display is carried out via the calibration device Cal PX or the PC software PC-Soft 80. Sensors with LCD display have an integrated calibration routine that is started from outside by a permanent magnet without opening the housing. In case of an alarm or fault the back light of sensors with LCD display changes from green to red.


APPLICATION
The PolyXeta®2 sensor is used in industrial areas like oil/gas industry, biogas plants, petrochemical industry, power plants etc. in Ex-Zone 2. The PolyXeta®2 sensor is also suitable for commercial areas like gas transfer stations etc. With the 4 – 20 mA / RS485-ModBus output signal the sensor is suitable for connection to the PolyGard®2 gas controller series by MSR-Electronic, as well as to any other controller or automation devices. Optionally, the PolyXeta®2 sensor is also available with LCD display and relay output.

FEATURES
 ATEX and IEC Ex certificates MSR-Electronic for electrical Ex protection
 ATEX metrical test & SIL2 safety functions 4 – 20 mA, RS485 and relay
 Type “Ex d” with flame-proof enclosure
 Continuous monitoring
 Microprocessor with 12 bit converter resolution
 Self-monitoring system
 Easy calibration
 Calibration service by exchanging the sensor head
 Proportional 4 – 20 mA output
 Serial interface to the control center

For more details and datasheet Click here:-polyxeta-2-2-xxxx-a